Parking Stand Replacement Instructions
©2004 Segway LLC Page 3 of 4 18250-00001ab
Step 2 Disengage the Parking Stand lever from the Mat.
Step 3 Take a moment to review the position of the
Parking Stand, as a point of reference for your
installation.
Step 4 Remove the Parking Stand.
>
Installing the Parking Stand
Step 1 Place the new Parking Stand Assembly against the
side of the Platform, aligning the two fastener
locations. The extrusion on the Parking Stand
bracket will seat into the larger hole beneath the
left fastener location.
Step 2 Thread in the two new 4 mm Hex fasteners.
Torque to 0.5 N-m.
>
Installing the Fender
Step 1 Position the bottom left edge of the Fender into
place first. You will need to twist and flex the
bottom right edge until it seats flat against the
Gearbox. When seated properly, the six fastener
locations will align with the fastener locations in
the Chassis and Gearbox.
Step 2 Thread in and finger-tighten the six new Fender
fasteners, beginning at the bottom edges of the
Fender. Torque to 1.5 N-m using a T-20 six-lobed
bit (Torx T-20). Over tightening could strip
aluminum threads.
Step 3 (i Series and e Series models) Reach behind the
Fender and reengage the mat loop into the
Fender.
>
Installing the Tire/Wheel Assembly
Step 1 Clean any debris from the outside of the Drive
Shaft and the inside of the Wheel Hub Taper using
isopropyl alcohol and a clean rag.
Step 2 Align the Tire/Wheel Assembly with the Wheel Hub
Taper over the Drive Shaft. Rotate the Wheel while
pressing down until the Wheel seats.
Step 3 Thread on the Wheel Nut. To reduce the risk of
cross threading, use only the socket (without the
wrench) to start the Wheel Nut.
Step 4 Position the Segway HT with the Wheels on a non-
slip surface. Brace the Wheel so it will not rotate
when you tighten the Wheel Nut; torque to 50 N-m.
To Next Page
Loading...