!
For!personalized!technical!support!with!Nineb ot !products,!please!contact!!9Bot!
Store!Technical!Support!at!info@9bot-store.com!
!
1!
!
Parking(Stand(Removal(and(Installation(
Instructions(
Tools%Required:%%
2.5 mm hex wrench
Phillips-head screwdriver
!
Removal%%
1. Make sure the Ninebot PTR is powered off and the charger is not
connected.
2. Tip the unit onto its side, being careful not to scratch or mar the
wheels or handlebar.
3. Using a 2.5 mm hex wrench, remove the left two fasteners shown
in Figure 1.
4. Using a Phillips-head screwdriver, remove the remaining two
fasteners.
5. Remove the Parking Stand (Figure 2).
Installation %%
1. Install in the reverse order of removal.
To Next Page
Need help?
General
