Section 8: Repairs
Bambi Bucket Service Manual – Models 6072-1821 38
3. The spring reel must be turned in the counter-
clockwise direction to tension the spring. Disconnect
the elastic band on the vinyl coated cable and slowly
pull the cable off the reel. Count the revolutions of
the reel as you pull out the cable
4. Once you reach the end of the vinyl coated cable, lock
the reel with vise grips.
5. Wrap the vinyl covered cable back around the spring
reel. Remove the temporary lock and, again, pull the
cable out. Repeat until the spring reel has turned 24
revolutions total, or until the reel stops. Do not over-
tension (over-rotate) the spring reel. Over-
tensioning the spring will cause damage and may lead
to failure.
6. Back the spring reel off until the three holes are positioned at the top (approx. one full turn)
and secure the reel.
7. Remove the vinyl covered cable and discard. Re-install the tripline (see Tripline
Replacement).
To Next Page
Loading...
Need help?
General
