SEI Industries Bambi Bucket Series Service Manual

Section 8: Repairs
Bambi Bucket Service Manual – Models 6072-1821 44
8. Once the IDS is fully installed, test for fit. You should be able to pull the hub past the
midpoint position with a slight effort. If the IDS is either too loose or too tight, it will require
adjustment. If the IDS is too tight, adjust as follows:
a. Cut off one spoke just above the existing hole on one end only. Redrill a new hole
centred the same distance from the new end of the spoke as the other spokes.
Replace the spoke and check for fit.
b. If the IDS is still too tight remove another spoke directly across from the first
modified spoke and repeat the previous step.
9. Pass the tripline through the hub and re-attach to the dump valve
10. Attach the IDS deployment cable to the control head small adjustment chain.
11. Attach the IDS restrainer cables.
Bottom Loop Repairs
If the bottom loops, which hold the chain, become worn, the frays can be melted with a lighter to pre-vent
them from spreading. If the bottom loops re-quire replacement, they should receive an overlay of heavy
duty wear-resistant webbing.

SEI Industries Bambi Bucket Series Specifications

General

Brand	SEI Industries
Model	Bambi Bucket Series
Category	Other
Language	English