EasyManua.ls Logo

SEI FA515500 - Location and Electrical Setup; Fireplace Placement Guidelines; Electrical Connection Requirements; Cleaning the Metal Trim

Default Icon
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
POSITIONING/LOCATING
POSITIONING/LOCATING
POSITIONING/LOCATING
POSITIONING/LOCATING YOUR
YOUR
YOUR
YOUR
CHARMGLOW
CHARMGLOW
CHARMGLOW
CHARMGLOW ELECTRIC
ELECTRIC
ELECTRIC
ELECTRIC FIREPLACE
FIREPLACE
FIREPLACE
FIREPLACE
When choosing a location for your new fireplace, ensure that the general instructions are
properly followed. For best result, install the fire place out of direct sunlight.
ATTENTION
ATTENTION
ATTENTION
ATTENTION Cold climate installation recommendation: When installing this unit against a
non-insulated exterior, it is mandatory that the outer walls be insulated to conform to
applicable insulation codes.
ELECTRICAL
ELECTRICAL
ELECTRICAL
ELECTRICAL CONNECTION
CONNECTION
CONNECTION
CONNECTION
A 15 AMP,120 Volts,60 Hz circuit with a properly grounded outlet is required. It s
recommended that the fire place will be on a dedicated circuit as other appliances on the
same circuit may cause the circuit breaker to trip or blow the fuse to blow when the heater is
in operation.
CLEANING
CLEANING
CLEANING
CLEANING TRIM
TRIM
TRIM
TRIM
Clean the metal trim using a soft cloth dampened with a citrus oil based product and buff
with a clean soft cloth. DO NOT use brass polish or household cleaners as these products
may damage the metal trim. Citrus oil based products can be obtained at supe rmarkets or
hardware stores.
ELECTRICAL
ELECTRICAL
ELECTRICAL
ELECTRICAL SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
Voltage:
120VAC, 60 Hz
Amps:
Amps:
Amps:
Amps:
12.5
12.5
12.5
12.5 Amps
Amps
Amps
Amps
Watts:
1 5 00 Watts
Lighting:
LED