Seiko 4F32A - Page 9

8
TECHNICAL GUIDE
II. REMARKS ON DISASSEM BLING AND REASSEM BLING
Cal. 4F32A, 8F32A, 8F33A, 8F35A
● Hour, minute and second hands
• For disassembling and reassembling, use the movement holder for exclusive use with the respective
calibres.
• When installing the hands, place the movem ent directly on a flat metal plate or a riveting plate.
• How to set the hands
With the battery installed, place the movement directly
on a flat metal plate or a riveting plate, taking care not
to press dow n the hooking portions.
To install the hands:
Turn the crown clockwise until the date changes, and install the hands so that they point to the 12 o’clock
position.
To install the hands so that the date changes more accurately as the hands indicate 12 o’clock midnight:
1) Turn the crown clockw ise until the date changes.
2) Give the crow n four counterclockw ise turns to m ake the date return to the previous date.
3) Turn the crown slow ly clockw ise until the date changes again.
4) Install the hands so that they point to the 12 o’clock position.
• Setting position of the movement on the exclusive movement holder
Check that the pins of the m ovem ent holder are securely set to the corresponding holes of the
movem ent.
[ Movement holder 4F3-T for the dial side of Cal. 4F32A movement ]
[ Movement holder 8F3-T for the dial side of Cal. 8F32A, 8F33A and 8F35A movements ]
Hooking portion
Battery
Pin
Hole to set the pin
Pin
Hole to set the pin