There are 3 types of special clasps as described below;
2
If the clasp of the watch you purchased is one of them, please refer to the indications.
A A Type P.45
C C Type P.47
B B Type P.46
TO PRESERVE THE QUALITY OF YOUR WATCH
TO PRESERVE THE QUALITY OF YOUR WATCH
EN 43
EN 44
TO PRESERVE THE QUALITY OF YOUR WATCH
A A Type 1 Lift up the clasp to release the buckle. 2
Buckle
Fixed loop
Flap
Movable loop
2 Open the flap.
3 Remove the pin from the adjustment hole. Slide the band left and right, and reinsert the pin into the adjustment hole
at an appropriate length. Pin Adjustment hole
4 Fasten the flap.
* Do not push the flap in too hard.
EN 45
C C Type 2
* When fastening the clasp, insert the tip of the band into the movable loop and fixed loop, and then, securely tighten
the clasp.
TO PRESERVE THE QUALITY OF YOUR WATCH
How to wear or take off the watch
1 While pressing the push buttons on both sides of the flap, pull the band out of the movable loop and fixed loop.
Then open the clasp.
2 Place the tip of the band into the movable loop and fixed loop, and fasten the clasp by pressing the frame of the
buckle.
Buckle
Fixed loop Movable loop
Push button Flap
EN 47
B B Type 2
TO PRESERVE THE QUALITY OF YOUR WATCH