What does it mean when the ERROR LED lights up on my Seiko DPU-414 Printer?
If the ERROR LED lights up on your Seiko printer, it is likely due to paper jams preventing the head from scanning. Remove the paper jam to resolve this issue.
What to do if nothing is printed on my Seiko DPU-414?
If nothing is printing on your Seiko printer, several factors could be responsible. It might be due to a disconnected FPC for the head, in which case you should replace the printer unit. Another possibility is the disconnection of the connector of the FPC for the head or the head scanning motor; ensure that you insert the connector correctly. Other causes include a burned thermal head (replace the printer unit), reverse setting of the thermal paper (set the thermal paper correctly), using non-thermal paper (use the specified thermal paper), a disconnected load wire for the head scanning motor (replace the printer unit), or a defective main board (replace the main board).
Why Seiko printer has no power with the AC adapter?
If your Seiko printer has no power when using the AC adapter, it could be due to several reasons. A flat ribbon cable might be disconnected, requiring you to replace it. Alternatively, there might be defective soldering for the LED or a defective LED, suggesting a replacement of the switch board. Other potential causes include a disconnected AC adapter (replace the AC adapter) or a defective main board, which would necessitate replacing the main board.
How to fix Seiko DPU-414 Printer battery that is not charged?
If the battery of your Seiko printer is not charging, it could be due to a charging time setting error, so set the charging time correctly. It may also be caused by a defective voltage of the battery, in which case you should replace the battery pack. Another cause could be a defective AC adapter, so replace the AC adapter.
Why is my Seiko printer printing with defective density?
If your Seiko printer has defective printing density, it may be due to a defective thermal head resistance, requiring you to replace the printer unit. Another cause could be a defective contact between the FPC and the connector, so insert the FPC to the connector correctly again. Also, ensure you're using the recommended thermal paper and that the dipswitch setting is correct. Finally, check if there's an error in the head rank or applied energy setting, and adjust the applied pulse width correctly.
Why Seiko printer has no power without the AC adapter?
If your Seiko printer has no power without the AC adapter, the battery may not be charged; charge it with the AC adapter. Another possible cause is a disconnected connector; in this case, insert the connector correctly.
How to troubleshoot Seiko DPU-414 if the power does not turn on?
If your Seiko printer's power does not turn on, first, turn on the Power Switch. Also, plug other electrical appliances into the outlet to check that it is working.
What to do if Seiko DPU-414 is not initialized?
If your Seiko printer is not initialized, it could be due to a defective timing switch, so replace the printer unit.
What causes shortened printing in horizontal direction on Seiko DPU-414?
If your Seiko printer is experiencing shortened printing in the horizontal direction, it could be due to step-out of the head scanning motor (abnormality of the drive voltage of the head scanning motor), so replace the main board. Another cause could be step-out of the head scanning motor (attachment of alien substances around the head carrier), so remove alien substances.
What causes abnormal sound emitted from Seiko printer?
If your Seiko printer emits an abnormal sound, it could be due to the attachment of alien substances around the head carrier or to gears concerned with the paper feed; in both cases, remove the alien substances. Another cause might be an awry FPC for the head, so set the FPC correctly.
General| Type | Dot Matrix Printer |
|---|---|
| Print Method | Impact |
| Print Width | 80 mm |
| Interface | Serial, Parallel, USB |
| Number of Columns | 40, 80 |
| Power Supply | AC 100-240V |
| Number of Pins | 9 pins |
To Next Page
