Selec PID110 User Manual

ONLINE DISPLAY OPTION
This function allows user to view online display options.
NOTE:
The parameters shown below are not prompted if they are locked in level 6.
DISPLAY DESCRIPTION
Set point 1
Set point 2
Set point 3
Proportional band - heat
Integral time
Derivative time
Auto tune
Hand output percentage
Manual reset
Proportional band - cool
DISPLAY CONDITION
Ramp set point
31
Online access for Set 2 not
valid if Auxillary output =
Sensor Break / OFF /
Retransmission
Online access for Set 3 not
valid if Alarm mode =
Sensor Break / OFF.
Online access for Auto tune
is not valid if PB-Heat=0
and HC =no or PB-Cool=0.
This parameter is not
prompted if Pb- H = 0
Integral time is not
prompted if PB = 0
Derivative time is not
prompted if PB = 0
Manual reset is prompted
only if Integral-main=0
and PB-heat > 0.
This parameter is prompted
only if HC = yes.
This parameter is prompted
only if Ramp is ON / Hold.
This parameter is read only
and cannot be altered.
Programming

Selec PID110 Specifications

General

Brand	Selec
Model	PID110
Category	Temperature Controller
Language	English