TEC Series v 3.2X
Page 25
SETUP AND PROGRAMMING
Setup refers to configuration of a TEC, usually during installation. This may include how long the door
entry time is, or what number energizes the door control relay. Any options such as card readers or
automatic unlock and re-lock, are configured at this time. The installer of the TEC generally performs
these tasks.
Programming refers to the entry of codes, names, phone numbers, and PINs (Personal
Identification Numbers). The end user or customer generally enters the data, and periodically updates
it as required.
If the factory defaults shown on Pg. 28 and 29 are adequate for an installation, then the
following "Quick Programming" section will give an example of a typical code entry. No explanations
about menu selection function will be provided. SES strongly recommends that installers without
previous experience in telephone entry control systems read this manual in it's entirety.
QUICK KEYPAD PROGRAMMING EXAMPLE
This example assumes all factory defaults, including factory default passcode 777777 are in
the TEC and you have entered no other data. This benefits those with experience installing and
programming telephone entry systems.
This example enters the following data into the TEC from the keypad on the TEC front door:
CODE: NAME: PHONE: PIN:
001 SMITH,FRED 555-1234 1234
123 DOE,JOHN 555-9876 5678
1. To begin programming press the "*" and the "0" keys simultaneously.
2. Enter passcode number 777777.
3. Press *.
4. Press 1.
5. Press 1.
6. Press 001*.
7. Press 777#6#444#8#44#1111#333#77#33#3#*5551234*1234*.
8. Press 123 *.
9. Press 3#666#33#1111#5#666#44#66#*5559876*5678*.
10. Press the "*" and the "0" keys simultaneously.
Press the # key twice. You should see both codes and names in the display (one after the
other). If you had any problems entering the data, or if you did not understand the reason for a key
entry, please read the rest of this manual.
To Next Page
Loading...