User’s Guidelines
Thank you for choosing this Sellstrom Manufacturing Co., Inc. Personal Eye Protector. This personal
eye protector is in compliance with the European Directive 89/686/EEC and to the harmonized technical
standard EN 166.
PERSONAL PROTECTION EQUIPMENT
This product has been tested and approved in accordance to the following technical standards: EN
166 & EN 170
Eyes Protectors
The use of the eye protector and the standards it complies with are specied in the enclosed user’s
manual – “proper marking of the protectors according to their use”, considering its CE certication markings
present on the lter and on the frame. Storage, cleaning and maintenance: keep the protectors at normal
temperature in dry places. The lters shall be cleaned periodically. Always use warm water and soap to clean
the lenses. After washed, the protector shall be dried using a soft cloth. Daily check that physical conditions
of the protector are adequate. Scratched lters shall be replaced. Should lters require disinfecting, contact
Sellstrom Manufacturing Co., Inc. for advice. Wearers with an extremely delicate skin could develop allergic
reactions if they are in contact with the eye protectors materials (temples, nose pads, etc.)
Classication
Face screens: Mod. MP 4 CV ( Clear Visor) provide protection against basic impacts, high speed particles
(B-120 m/s), resistance to surface damage by ne particles and are able to protect against optical radiation,
liquid droplets and short circuit electric arc.
Accessories: The oculars of some models are interchangeable but in order to maintain the safety of the eye
protector it is essential that the new oculars be the t ones. Ask Sellstrom Manufacturing Co., Inc. for advice
about spare parts availability. Should you need to replace any of the eye protector’s components, please check
the instructions supplied by Sellstrom Manufacturing Co., Inc..
Life of the product: Aging should not produce impairment on the eye protector if stored under perfect
conditions at a range of 5° - 30° Celsius room temperature. However, if any impairment should be noticed, the
product shall be changed. The product should be changed after three years of normal use. If on the marking is
present a letter (F,B,A) followed by letter T , the faceshield protects the user against mechanical impact by high
speed particles at extreme temperature (from -5°C to +55°C), therefore if is not present the letter T the face
shield protects the user against mechanical impact by high speed particles only at room temperature.
Packing: Always transport the product inside a case or a cover and never with tools or metallic objects.
Manufacturered by SELLSTROM MANUFACTURING CO., INC. A SureWerx Brand
Phone: 1 (847) 358-2000
Notied Body: Certottica S.c.a.r.l. (Notify Body number 0530), Z.Ind. Villanova, 1 – Longarone (BL) – ITALY
WARNING!
The scratched or damaged oculars should be replaced immediately. Don’t use the visor with damaged oculars,
it could be cause injuries. The visor protects against high speed particles however wearing it over standard
ophtalmic spectacle may transmit
impacts. Be careful wearing ophthalmic spectacles using the visor too close to the face it maybe dangerous a
cause of injuries.
Meaning of the MARKING.
HOLDER MARKING The visor and the holder has the following marking code:
European Conformity symbol: CE
Manufacturer identication: SM
Field/s of use: (if applicable-see table below) …..
Mechanical strength symbol ….
(if applicable-see table below)
INST-DP4 rev. 7
Product that works.
ENGLISH
To Next Page
Loading...