Sellstrom
®
WHB1000 Automatic
Welding Helmet
Installation, Operation & Maintenance Manual
Sellstrom Manufacturing Co.
Elgin, IL 60123
Phone: (800) 323-7402
www.surewerx.com
© Copyright 2017, Sellstrom Manufacturing Company
Instruction: INST-WHB1000
Effective: 11/2017
S26100
WARNING!
Under Penalty of Law:
These instructions are not to be removed except by the user of this equipment.
Current instructions must always be available to any potential user. Note:
Because of continuous developments in the application and use of Sellstrom
®
equipment and our desire to serve your best interests, these instructions are
invalid 10 years after the effective date on these instructions. If you purchase a
product, and these instructions are out of date, call Sellstrom
®
Customer Service
and request current instructions. Dial toll free (800) 323-7402 (U.S. and Canada)
or (847) 358-2000.
If you have difficulty or experience any problem with Sellstrom
®
equipment or the
instructions, call the above toll-free number or (847) 358-2000 immediately and
ask the Customer Service department for assistance.
You must read and fully understand or
have the following instructions explained
to you before using this equipment.
Failure to do so could result in serious or
fatal injury.
READ ALL SAFETY AND WARNING INSTRUCTIONS CAREFULLY before attempting to install, operate or service your auto-
darkening welding helmet. Consult with a qualified instructor or supervisor if you have questions. Your failure to comply
with the instructions could result in personal injury and/or property damage. The welding helmet must only be used with
the following equipment: auto-darkening filter, cover plate and headgear
Arc welding without protection is dangerous. Auto-darkening welding filters provide reliable protection against UV/IR emissions, heat, sparks and
spatters in both the light and dark state. The protection shade of the filter is designed to protect the eyes from the bright light of the welding arc.
Auto-darkening filters must always be used with welding helmets. Welding helmets equipped with auto-darkening filters are easy to use. There is no
need to lift and lower the welding helmet during welding. When striking an arc, the auto-darkening filter automatically darkens. With the disappearance
of the arc, it returns to the original light state. The following advantages result from this hands-free use, UV/IR protection for eyes and skin, no blinding
light interference, faster and more efficient welding, higher quality, and less fatigue.
To Next Page
Need help?
General