Seltron T1 - Page 14

Group S1 is by default (factory) settings locked.
For unlocking the group S1 see chapter Service group S1.
SETTING MANUAL
14
Picture 20
Picture 21
Successive Nr.
of the line
Group
name
Parameter
Time program CH1
For changing the time program see chapter Modifying the time
program (page 10).
Data group d1
This group is sort of T1 identification. Group d1 only shows data
about T1, meanwhile changing isn’t possible. Group d1 contains
the following data:
- [d1.1] thermostat type (T1)
- [d1.2] software version
- [d1.3] heating or cooling
- [d1.4] ED constant and regulated object
- [d1.5] temperature sensor calibration
- [d1.6] reserved
Entrance
GB