PREPARATION
Getting to Know the Prism Tube Layout
Camera
Lens Cap
Lens
Slide Switch
SD Card Format Button
DC Power Charging &
Firmware Upgrade Port
Status LED
Rear Cap
Fault Reset
Pin-hole Button
MicroSD Card
Slot
Speaker and Microphone
Speaker
Wired
Microphone
Hook and Loop
Fastener for Speaker
Rear Cap for USB Cable
USB Cable for Speaker &
Microphone
Hook and Loop Fastener
for Wired Microphone
Installing the Prism Tube System
Connecting the Speaker
1 42 3
Note Connect the speaker cable to the USB cable’s black connector.
Mounting
Clamp Unit Camera
1
2
BASIC OPERATION
Turning the Camera On or O
To Turn On the Camera and Start Recording
ON
“Camera on”, “Recording”
To Turn O the Camera and Stop Recording
OFF
“Camera o”
Note • Recording will start shortly after the camera is turned on. Recording stops
shortly before the camera is turned o.
• A microSD card must be inserted to record video.
Adjusting the Angle Speaker
1
2 3
Note • The tube swivel mount wheel must be fully tightened after adjusting the
camera angle.
• Make sure the tip of the slide switch faces upwards and is parallel to the
ground.
• You can use the glued surface mounting plate to attach the clamp unit to
the surface of the helmet. Full adhesion is achieved after 24 hours.
Connecting the Wired Microphone
To record your voice more clearly, connect the wired microphone.
Note • Connect the wired microphone cable to the USB cable’s red connector.
• The camera’s internal microphone automatically turns on when the wired
microphone is disconnected.
Others
Clamp Unit Tube Swivel Mount
Glued Surface Mounting Plate USB Power & Data Cable
Allen Wrench
Inserting a MicroSD Card
1 2 3
Note Optional microSD cards up to 32 GB are compatible with the Prism Tube.
To Next Page
Need help?
General
