Phone, Music Pairing
1. Press and hold the Phone Button for 5 seconds until you hear a voice prompt, “Phone pairing”.
2. Search for Bluetooth devices on your mobile phone. Select the Sena Savege
in the list of the devices detected on the mobile phone.
3. Enter 0000 for the PIN. Some mobile phones may not ask for the PIN.
4. The mobile phone confirms that pairing has been completed
and the Savage is ready to use. You will hear a voice prompt, “Your headset is paired”.
Music Operation
Play or pause music : press and hold the Jog Dial for 1 second
To track forward or track back : rotate while pressing the Jog Dial clockwise or counter clockwise.
Mobile Phone Call Making and Answering
Answering a call: Tap the Phone Button or the Jog Dial
Ending a call: Tap the Phone Button or press the Jog Dial for 2 seconds
Voice dial: Tap the Phone Button in stand-by mode to activate the voice dialer
Speed dial: Double tap the Phone Button
Rejecting a call: Press the Jog Dial for 2 seconds
Intercom Pairing
1. Press and hold the Jog Dial of the headset A and B for 5 seconds until red LEDs of the both units
start to flash rapidly
2. Tap the Jog Dial on any one of the two headsets
Intercom Start/End
1st Friend: Tap the Jog Dial once.
To Next Page
Loading...