Sena TUFFTALK - Quick Start Guide Manual

PREPARATION
Knowing the Headset Layout
Left
Jog Dial
Status LED
PTT Button
Short Antenna
PTT Port
Two-way
Radio Port
Right Ear Cup
MIC Port
Right
Charging LED
Left Ear Cup
Phone Button
Right Speaker
Cover
DC Power
Charging &
Firmware
Upgrade Port
Ambient
Mode Button
BASIC OPERATION
Operating the Buttons
Tap the
button
Double tap the
button
Press and hold
the button for
5 seconds
Press the two
buttons at the
same time
Rotate the
Jog Dial
Turning On/O the Headset
1
ON You will hear ascending
beeps.
“Hello”
OFF
You will hear descending
beeps.
“Goodbye”
Simultaneously press and hold the Jog Dial and the Phone Button
for 1 second to turn on or o the headset.
Adjusting the Volume
You will hear a beep when the volume
reaches the maximum or minimum
level.
PAIRING
Pairing with Mobile Devices - Phone, Music
5
“Phone pairing”
Bluetooth
Bluetooth
Sena Tutalk
“Your headset is paired”
Using Phone Features
After Pairing…
Answering Calls
Ending Calls Rejecting Calls
or
or
or
“Hello”
until you hear a beep until you hear a beep
Making Calls
Using the Phone Keypad Using the Voice Dialer
Installing the Headset
2
1
1
2
Replacing the Antenna
1
2
Installing the Battery
Checking the Battery Level
Blinking
70~100%
Blinking
30~70%
Blinking
0~30%
Turn on the headset and check the battery level via the Status LED.
5
“High” 70~100%
“Medium” 30~70%
“Low” 0~30%
Or, press and hold the Jog Dial and the Phone Button for 5 more
seconds when the headset turns on. You will hear a triple beep
and a voice prompt.
Charging the Battery
Charging
Fully charged
AC adapter
or
Using the Speed Dial
You will hear a beep.
“Speed dial”
Voice Menu
• Last number redial
• Speed dial 1
• Speed dial 2
• Speed dial 3
• Cancel
Listening to Music
1
After Pairing…
Playing or Pausing Music Tracking Forward or Backward
until you hear
a double beep
Rotate While
Pressing