The document describes an inverter generator, available in two models: SC-8000i and SC-15000i. This device is designed to provide electrical power and comes with a user manual in multiple languages, including Romanian, Hungarian, Bulgarian, and English.
The generator's primary function is to convert mechanical energy into electrical energy, providing a portable power source. It is designed for outdoor use and includes safety features to prevent carbon monoxide poisoning and electrical hazards.
Important Technical Specifications:
The manual provides detailed specifications for both models:
- Model: SC-8000i / SC-15000i
- Starting Watts: 7500W / 13000W
- Running Watts: 7000W / 12000W
- AC Voltage: 230V for both models
- Frequency: 50 Hz for both models
- Phase: Mono for both models
- Power Factor: 1.0 for both models
- RPM: 3400 for both models
- Fuel Capacity: 26L / 40L
- Engine: SC460 (459cc) / SV750 (744cc)
- Engine Oil: 1.0 l / 1.5 l
- Noise Level @7m: 67 dB (A) / 75 dB (A)
- Autonomy @50% load: 11 hours for both models
- Autonomy @100% load: 6 hours / 5 hours
- Weight: 115 kg / 170 kg
- Dimensions (HxWxD): 820640780 mm / 972783873 mm
Usage Features:
The generator is designed for ease of use and safety. Key usage features include:
- Starting the Generator: The process involves turning the fuel switch to "ON," the engine switch to "ON," and pressing the "START" button for 5 seconds. The manual emphasizes ensuring no electrical devices are connected during ignition to prevent difficulty in starting.
- Stopping the Generator: To shut down, all electrical devices must be turned off and disconnected. The generator should then run without load for a few minutes to stabilize internal temperatures, followed by turning both the engine and fuel switches to "OFF."
- AC Receptacles: These are used to power various appliances, lighting, tools, and motor loads. Users are advised to check the electrical rating of devices to ensure they do not exceed the generator's maximum power rating.
- Low Idle Mode: This mode helps control engine speed and conserve fuel. The engine idles when no appliances are connected and increases speed when a load is added. For large electrical loads connected simultaneously, it's recommended to turn the low idle mode to "OFF" to reduce voltage variations.
- Fuel Gauge: A mechanical device indicates the fuel level in the tank, with a red indicator showing full or empty.
- Ground Terminal: For electrical shock protection, the generator must be properly grounded using the ground terminal on the frame.
- LED Display: LEDs provide feedback on the generator's status, indicating if it's in use, overloaded, or requires lubricant.
- Parallel Kit (Optional): Non-polarized parallel kit terminals allow two generators to be linked to increase power output. The manual stresses reading the parallel kit instructions before use.
- High Altitude Operation: Specific modifications are required for high-altitude use to maintain performance and reduce emissions. Users are advised to contact an authorized service center for these modifications.
- Fuel Type: The generator uses unleaded gasoline with an octane rating of 86 or higher. E15 or E85 fuels (containing more than 10% ethanol) are not recommended as they can damage the unit and void the warranty.
Maintenance Features:
Regular maintenance is crucial for the generator's performance and longevity. The manual outlines a comprehensive maintenance schedule:
- Engine Oil:
- Checking/Adding: The oil fill cap/dipstick is used to check the oil level. SAE 10W-30 4-stroke engine oil is recommended for general use. The manual warns against starting the engine without proper oil fill.
- Changing: Engine oil should be changed every 100 hours or 6 months. It's recommended to drain the oil while the engine is warm but not hot for a quicker and more complete drain. Used oil must be disposed of at an approved site.
- Air Filter:
- Checking/Cleaning: The air filter should be kept clean for proper performance. It can be washed with warm, soapy water, rinsed, and squeezed dry. Incorrect installation of filters can lead to engine wear.
- Spark Plug:
- Replacement: The spark plug should be properly gapped (0.028-0.031 inches or 0.7-0.8 mm) and free of deposits. It should be inspected for wear, fouling, cracks, or chips. An improperly tightened spark plug can overheat and damage the engine.
- Fuel System:
- Draining: To prevent gum deposits, fuel should be drained from the tank and carburetor before storage. A manual gasoline pump is recommended for draining the tank.
- Fuel Stabilizer: Adding a fuel stabilizer (not included) can extend fuel life and prevent deposits. It should be mixed with gasoline before filling the tank.
- Spark Arrester: This component should be serviced every 100 hours to ensure proper functioning. Carbon deposits should be removed with a brush, and the arrester should be replaced if damaged.
- Storage: The manual provides guidelines for storing the generator based on duration (less than 2 months, 2 months to 1 year, 1 year or more), including draining fuel, adding engine oil to the spark plug cylinder, and changing engine oil.
The manual also includes a troubleshooting section for common issues like the engine not starting, lack of power, or AC receptacles not working, offering possible causes and solutions. For persistent problems, users are advised to contact an authorized service center.
To Next Page
Need help?
General
