Sencor SHA 8400WH-EUE3 - Page 9

Air Purier
SHA 8400WH
EN
EN-9
2020 11/2020
• From the main unit A4 remove the frame with the lters A7. The frame has holders on both sides for easier removal.
D
• Use avacuum cleaner with an attached upholstery brush nozzle to remove the dirt from the pre-lter and
activated carbon lter. The pre-lter is attached to the frame with the combination lter with a velcro zip. Remove
the pre-lter from the frame and vacuum out the activated carbon lter located underneath it. When cleaning,
proceed with care so as not to damage any of the lters.
• In the event of signicant soiling of the pre-lter, wash it in lukewarm warm water. Then allow it to dry naturally.
Attention:
The activated carbon lter and HEPA lter are not washable.
• After cleaning, reinstall the pre-lter into the frame. Before reattaching the pre-lter into the frame, make sure
that it is completely dry. Reinstall the frame with the lters A7 into the main unit A4 and close the cover A9.
When inserting the lters, make sure that the HEPA lter points backwards towards the fan A3 and the pre-lter
forwards towards the front cover A9. The holders located on the sides of the frame point outwards from the
main unit A4 towards the front cover A9.
• Aashing LED indicator B1 will inform you when the lters A7 need to be replaced. The lifetime of the lters
A7 is approximately 6 months during standard use. You can purchase new lters from your vendor. Usually it is
necessary to only replace the frame with the activated carbon lter and HEPA lter and to reattach the exiting
pre-lter to it. Nevertheless, in the event that the pre-lter shows signs of wear, replace it also.
• After replacing the lters, it is necessary to restart the purier. Connect the power cord to apower socket. Turn on
the purier and then press button B5 and hold it down for approximately 5 seconds. This will restart the purier
and LED indicator B1 will stop ashing.