Sencor SHI 780 - Page 5

HAIR STRAIGHTENER
SHI 780
Procedure for ironing hair
1) Thoroughly wash the hair, dry the hair and brush through thoroughly so that it is smooth and
without knots.
2) Separate this prepared hair using clips into equally wide strands (about 5 cm wide).
3) Start to iron the back part of the head at the lower strands of hair — at the root place the strand
of hair between the plates and gently press the handle of the iron. With a sliding motion pull the
iron all the way to the ends of the hair.
4) Repeat the procedure for the same strand of hair until you achieve the desired appearance.
5) Continue in the same way with the remaining strands of hair (first on the front part of the head
and ending at the sides).
6) Before the final combing, allow the hair to fully cool down.
Note:
A e Do not leave the iron on the one spot for longer than 2 seconds as hair could be burnt.
e Use the iron only on healthy hair.
e Do not use the iron on oily, stuck together or sweaty hair.
e On perm or coloured hair only use the iron infrequently.
Q- Tip:
e Adjust the speed of movement of the iron on the hair strands to their character (fine hair
is more sensitive to a hot surface and requires a significantly shorter ironing time than
stronger hair).
Appropriate temperature settings for various types of hair:
1) For straightening rough, curled or hard hair:
e set a higher temperature (180° C to 230°)
2) For fine, slight to medium curled hair:
e set a lower temperature (120° C to 180° C)
3) For blended or coloured hair:
e start at a low temperature and gradually increase it
Copyright © 2010, Fast CR, a.s. Revision 12/2010