Sencor SHM 5205 - Page 4

Hand Mixer
SHM 5205
Use of appliance
1. To set up the appliance, insert the end of the mixing adaptor into the opening (see picture 1). Press the
adaptor in, until it clicks into the secured position. (Note: It is necessary to proceed accordingly when
attaching the adaptor for kneading. Insert the kneading adaptor with a handle into the opening with a gear
design and the kneading adaptor without handle into the opening without a gear design (see picture 2).)
2. Add the ingredients to the bowl.
3. Submerge the mixing or kneading adaptor into the bowl with ingredients (see picture 3).
4. Connect the electric cable of the appliance into the power point, turn on the appliance and select the
desired speed (see picture 4). While mixing, do not place objects into the bowl such as a kitchen knife,
or fork. This could lead to injury or damage to the appliance.
5. If you would like to mix using the highest speed, press the TURBO button (see picture 5).
6. When finished using it, shift the switch into the 0 position and remove the cable from the power point.
Press the button to release the adaptors to release the beating, or the kneading adaptors (see picture
6). It is possible to release the adaptor only once the switch is in O position. If the switch is positioned
between 1-5, the adaptors are blocked from release. To whip, mix, or knead, always use the same type
of adaptor. It is not possible to combine the kneading and mixing adaptors.
Adaptor for kneading
Use for kneading yeast dough, batter and pasta dough, to mix minced meat, spreads, or puff pastry.
© Copyright 2012, FAST CR, a.s. Revision 06/2012