Sencor SLE 1955M4 - Page 20

If you select DVB-T, then select the tune type and the country of installation and to start
tuning, press the OK button.
« Tune Type DTV+ATV >
A
Netherlands Portugal
If you select DVB-C, then select the DVB-C system configuration (tune type, frequency, ID
network, KS/S symbols). Then press the button for entering the tune type and the country
of installation. This step is the same as for DVB-T, select the tune tupe (DVT/ATV). Select
the country of installation and to start tuning, press the OK button.
DVB-C Scan Menu
Scan type Full
Frequency 610000
Network ID Auto
Symbol(KS/S) Auto
GO OK X MENU
The channel scan will commence. This operation may take several minutes. The progress
nformation bar is shown on the screen with information about the scan and the channels
found.
you want to skip the ATV scan, press the MENU button to interrupt the scan half
ay through. A dialogue box will appear on the screen, with the « button, select Yes
(Yes) to confirm. Then you will go directly to the DTV scan. You may repeat the above
described step if you also wish to skip the DTV scan. After turning on the television again,
a message about the installation of the television will be shown.
<=
18 EN
Copyright © 2014, Fast ČR, a. s. Revision 04/2014