Toaster
STS 30WH / STS 31GR / STS 32BL / STS 33OR / STS 34RD / STS 35VT / STS 36YL / STS 37GG / STS 38RS
EN
EN-5
Copyright © 2014, Fast ČR, a.s. 11/2014
DESCRIPTION OF THE TOASTER
A
STOP
2
1
3
4
6
1
6
5
4
3
2
7
5
1 Toaster opening for inserting bread products
2 Control lever with the "High Lift" function for lifting smaller bread products
3 DEFROST button for toasting frozen bread products
4 REHEAT for repeated heating of a toast
5 Electronic toasting intensity dial
6 STOP button to immediately stop operation
7 Crumb tray (not shown, located in the bottom part of the toaster)
OPERATION OF THE TOASTER
1) Before use, take the appliance and its accessories out of the packaging material.
2) Connect the toaster to a power socket. Insert a slice of toast bread, slice of bread or half a roll, etc.
into the toasting slot. When selecting bread products for toasting check that its size is appropriate
for toasting in your toaster. The bread product must not project out of the toaster. Bread slices must
not be too thick so as not to become jammed in the toasting slots.
NOTE: Before first use the toaster must be started empty at least three times for the maximum
toasting time to remove any potential odours.
3) Set the toasting level in the range 1 to 6 (1 - lowest toasting level, 6 - highest toasting level). For fi rst
use we recommend that you set the middle toasting intensity. To toast another bread product you
can choose a different level depending on the type of bread and your taste.
4) Put the appliance into operation by pushing down the control lever.
Note: If the power cord is not connected to a socket the lever will not become secured in the lower
position and the appliance cannot be put into operation.
5) The toaster will turn itself off as soon as the set toast level is achieved and will automatically eject
the inserted bread product. The toasting process can be interrupted at any time by pressing the STOP
button. Take out the toasts from the toasting slots and if necessary toast another bread product.
Note: Control lever with the "High Lift" function makes it easier to take out smaller bread products.
Lift the lever about 2 cm above the initial position and take out the bread product.
6) Disconnect the toaster from the socket after use and allow it to cool down before further handling.
To Next Page
Loading...