Seneca Z-TWS4 - User Manual

Page 1
MI003773
MI003770_121
SENECA s.r.l.
Via Austria, 26 – 35127 – Z.I. CAMIN – PADOVA – ITALY
Tel. +39.049.8705359 – 8705408 Fax. +39.049.8706287
Web site: www.seneca.it
Support: supporto@seneca.it (IT), support@seneca.it (Other)
Sales: commerciale@seneca.it (IT), sales@seneca.it (Other)
USER MANUAL
Z-TWS4
Z-PASS2-S
S6001-RTU
This document is property of SENECA srl. Duplication and reprodution are forbidden, if not authorized. Contents of the present documentation refers to products and
technologies described in it. All technical data contained in the document may be modified without prior notice Content of this documentation is subject to periodical
revision.
To use the product safely and effectively, read carefully the following instructions before use. The product must be used only for the use for which it was designed and
built. Any other use must be considered with full responsibility of the user. The installation, programmation and set-up is allowed only for authorized operators; these
ones must be people physically and intellectually suitable. Set up must be performed only after a correct installation and the user must perform every operation described
in the installation manual carefully. Seneca is not considered liable of failure, breakdown, accident caused for ignorance or failure to apply the indicated requirements.
Seneca is not considered liable of any unauthorized changes. Seneca reserves the right to modify the device, for any commercial or construction requirements, without
the obligation to promptly update the reference manuals.

Summary

Preliminary Information and Warnings

Device Features Overview

Technical Specifications

Electrical Connections

Z-TWS4, Z-TWS4-IO, Z-PASS2-S, Z-PASS2-S-R01, Z-PASS2-S-IO Connections

Details electrical connections and pinouts for specific Seneca device models.

S6001-RTU Electrical Connections

Details electrical connections, power supply, and communication ports for the S6001-RTU.

LED Status Indicators

Z-TWS4 and Z-PASS2-S LEDs

Describes the status LEDs for Z-TWS4 and Z-PASS2-S models.

Z-PASS2-S-R01 LEDs

Details the status LEDs specific to the Z-PASS2-S-R01 model.

Z-PASS2-S-IO LEDs

Explains the status LEDs for the Z-PASS2-S-IO device.

Z-TWS4-IO LEDs

Details the status LEDs for the Z-TWS4-IO device.

S6001-RTU Front Panel LEDs

Describes the front panel LEDs for the S6001-RTU.

Discovering Device IP Address

FTP and SFTP File Transfer

StratON PLC Programming

Writing, Downloading, and Running First Program

Guide to developing and executing an initial PLC program using StratON IDE.

Seneca Libraries and Templates Installation

Steps to install Seneca libraries and project templates into the StratON IDE.

Creating a Project for Seneca CPUs

Process of creating a new project in StratON IDE using device templates.

Z-PASS2-S-IO Profiles

Describes the available I/O profiles for Z-PASS2-S-IO CPUs in Straton.

Z-TWS4-IO Profile

Explains the I/O profile available for the Z-TWS4-IO device in Straton.

Energy Management Protocols

Lists supported Energy Management protocols like IEC 60870 and IEC 61850.

StratON Redundancy Functionality

Details the StratON PLC redundancy feature for high availability.

Ethernet Port Configuration Modes

VPN Configuration and Usage

Single LAN VPN Setup

Configuration details for establishing a Single LAN VPN connection.

Point-to-Point VPN Setup

Configuration details for establishing a Point-to-Point VPN connection.

Network Redundancy

Router Functionality

Remote Connection Control

Automatic APN Configuration

M-Bus Communication Protocol

OPC Unified Architecture (OPC UA) Protocol

Firmware Upgrade via USB

Web Configuration Pages

Administrator Pages Overview

Accessing the device's web configuration site with administrative privileges.

Main View (Administrator)

Displays main device configuration parameters and their current values.

Network and Services Configuration

Configuration of network settings, Ethernet mode, and IP parameters.

Real Time Clock Setup

Configuration of Network Time Protocol (NTP) and device time settings.

VPN Configuration

Configuration of OpenVPN or VPN Box for secure remote access.

Router Configuration

Configuration of router functionality, including port forwarding and firewall.

OPC UA Server Configuration

Configuration settings for the OPC UA server.

Users Configuration

Management of user credentials for web access.

Firmware Upgrade via Web Interface

Procedure for upgrading the device firmware through the web interface.

Configuration Management

Saving and loading device configuration archives.

Modbus TCP Client Configuration

Configuration settings for the Modbus TCP client.

Mobile Network Settings

Configuration of mobile network parameters like APN and PIN.

DDNS Configuration

Configuration of Dynamic DNS service for remote access.

Digital I;O Configuration

Configuration of digital input/output modes and security levels.

I;O View for S6001-RTU

View current status for inputs/outputs and diagnostic information.

Firmware Versions

Displays firmware versions of various device components.

Ethernet Interface Status

Status information for the available Ethernet interfaces.

Modbus Modules Status

Status of configured Modbus RTU Slave modules.

M-Bus Scan Procedure

Procedure for scanning M-Bus devices and reading data.

M-Bus Configuration

Configuration and export of M-Bus scan results for Straton.

Data Logs Management

Accessing and managing data logs stored on the SD card.

User Pages Access

Accessing the device configuration as a limited-access user.

User Pages Main View

Displays network parameters and web user credentials.

User Pages Network and Services

Network configuration options available for user access.

User Pages I;O View (S6001-RTU)

Identical I/O view page as for administrator user.

Guest Pages Access

Accessing device configuration with minimal privileges.

Seneca StratON Library

Function Blocks Reference

Detailed descriptions of available function blocks and their parameters.

Functions Reference

Detailed descriptions of available functions and their parameters.

Z-NET4 Program Suite

Accessing Straton Variables

Shared Memory Access

Defining shared-memory areas and configuring PLC variables.

C Program Example for Shared Memory

Example C program to access shared-memory variables.

CGI Access to Variables

Accessing Straton variables using Common Gateway Interfaces (CGIs).

Seneca Z-TWS4 Specifications

General

Protection Class	IP20
Output	4-20 mA
Protocol	HART
Power supply	24 VDC
Accuracy	0.1%
Isolation	1500 VAC