Why is my Senix CHX2 Battery Charger flashing red and green?
If the red and green lights on your Senix Battery Charger are flashing alternately at a frequency of 1 Hz, it indicates that the battery pack temperature is outside of its working range. To resolve this, remove the battery pack from the charger and allow it to cool down for 15 minutes before attempting to charge it again.
This manual contains important safety and operating instructions for battery charger.
Read all instructions and cautionary markings on battery charger and battery.
Covers remaining safety instructions from point 6 to 20.
Covers 7 points of other warnings related to battery charger use.
Identifies components of the CHX2 battery charger including power cord, covers, and contacts.
Do not use the charger outdoors or in wet conditions to prevent electric shock.
Describes horizontal and vertical placement for charger operation and mounting.
Instructions for charging the Lithium-Ion battery pack, including initial charge.
Keep charger free of debris; wipe with cloth or use compressed air.
Disconnect power, use a box, avoid sunlight and heavy impacts during transport.
Addresses issues like charger not working, broken charger, and temperature warnings.
Covers defects in materials or workmanship on equipment and batteries for two years.
Details implied warranties, consequential damages, and state-specific rights.
General| Brand | Senix |
|---|---|
| Model | CHX2 |
| Category | Battery Charger |
| Language | English |
To Next Page
