EN - 20 WWW.SENIXTOOLS.COM
TROUBLESHOOTING
Suspected malfunctions are often due to causes that the users can x themselves. Therefore, check the product using this
section. In most cases the problem can be solved quickly.
PROBLEM POSSIBLE CAUSE SOLUTION
Product does not start
Battery pack not properly attached Attach properly
Battery pack capacity too low Remove and charge battery pack
Battery pack damaged Check by a specialist electrician
Switch trigger or interlocking switch not set on
ON position
Refer to chapter “SWITCHING ON/OFF”
Product does not reach
full power
Battery pack capacity too low Charge battery pack
Air vents are blocked Clean the air vents
Result is unsatisfactory Cutting attachment is worn Replace with a new one
Vibration or noise is
excessive
Bolts/nuts are loose Tighten bolts/nuts
Product suddenly stops
Battery pack capacity too low Remove and charge battery pack
Battery too hot
Remove battery pack and let it cool
down
To Next Page
Loading...
