Sennheiser 2020-D - User Manual

!

CHARGER

The charger can simultaneously recharge 20 receivers and 2 transmitter batteries.

The receivers are charged in the charging docks (as seen right).

The transmitter batteries are charged in the dual transmitter charging docks.

To charge the system remove the mains cable from the pocket on the inside of the storage case lid

and plug into the charger and a mains outlet.

Switch the charger ON.

A LED on each receiver and the transmitter charging dock will indicate the charging status:

Red=Charging in progress. Green=Fully charged.

A useful facility of the charger case is the COPY function. This allows the user to preselect all the

channels of the receivers with the push of one button. Place a receiver on the required channel into

the master charging dock and press the copy function button. This will instantly set all the other

receivers in the charger to the required channel.

1 IEC socket and mains switch

2 Handheld transmitter

3 Bodypack transmitter

4 Dual transmitter battery charging docks

5 Stethoset receiver

6 Receiver charging dock

7 Bodypack receiver

8 Master charging dock

9 Copy button

10 Copy available LED

11 Temp error LED

12 Power LED

13 Trolley frame mount (underneath)

Sennheiser 2020-D tour guide system - Quick guide

INTRODUCTION

Please read these instructions and familiarise yourself with the equipment before your event. The instructions are intended as a quick guide only. Should you require more information please refer to

the supplied manufacturers handbook (also available on the download section of our website) or contact us.

A tour guide system is a wireless radio system used to transmit a message from a presenter to listeners. The presenter simply speaks into a microphone and the listeners use receivers to hear the

message. A tour guide system can be used indoors and outdoors (with a maximum range of 100m). Up to 6 channels can be used simultaneously.

After each use, recharge all transmitters and receivers so they are ready for the next event.

Please turn over for transmitter and receiver instructions

ENSURE TRANSMITTER AND RECEIVERS ARE CHARGED PRIOR TO USE

Sennsis Tour Guide Systems, Sound Induction Systems Ltd, Unit 27 Mochdre Industrial Estate, Newtown, Powys SY16 4LE

V1019

5

1

2

10

9

8