Sennheiser electronic GmbH & Co. KG Phone +49 (5130) 600 0 Printed in China
30900 Wedemark, Germany Fax +49 (5130) 600 300 Publ.
10/06
www.sennheiser.com 517641 / A0
2
A
B
C
Connecting the system components
Plug in one end of the connecting cable
to the socket on your sound source (e.g. television).
If necessary, use one of the adapters
,
or
(not included)
.
Plug in the other end of the connecting cable
to the blue socket
on the transmitter.
Connect the mains unit to the transmitter and to the mains.
Place the receiver into the transmitter’s charging compartment .
Before you use the rechargeable battery for the first time, charge it for at least 14 hours.
Adjust the volume of your sound source to a sufficient (medium) level.
Switching on and using the stethoset receiver
Turn the volume control in the direction of “ON” until it clicks.
First adjust the volume to a low level. This protects your hearing from damage.
Then put the receiver on and adjust the volume to a comfortable level.
Use the balance control 쐋 to adjust the volume between the left and right ear.
If you cannot hear anything through the receiver, increase the volume of your sound source.
Switching off the stethoset receiver
To switch the receiver off, turn the volume control in the direction of “OFF” until it clicks.
Charging the stethoset reciever
Switch the receiver off. Place the receiver into the transmitter’s charging compartment without
exerting too much pressure. With a fully charged battery, the operating time is approx. 9 hours.
For details on the use of the Set 50 TV/Set 55 TV, please refer to the enclosed operating instructions.
Set 55 TV
Set 50 TV
Quick instructions
Need help?
General
