Table of contents
How does it work? ......................................................................................................... 3
Air sensor installation ..................................................................................................... 5
Hydraulic installation on a forklift .................................................................................... 8
Electrical installation ...................................................................................................... 9
Kimax 1 menu ............................................................................................................ 11
in menu ..................................................................................................................... 12
AdL menu ................................................................................................................... 12
Adh menu ................................................................................................................... 12
Calibration .................................................................................................................. 13
Alarms ....................................................................................................................... 14
Protecting your calibration ............................................................................................ 15
Daily use .................................................................................................................... 16
Serial output ............................................................................................................... 17
Troubleshooting .......................................................................................................... 18
Dimensions and technical specifications .......................................................................... 19
Warranty
Kimax 1 cabin, trailer and hydraulic are all covered by Sense-Tech Weighing Systems ApS
guarantee. Electronic failure and broken components caused by normal use are repaired or
exchanged when necessary, when sent to the factory.
Damage to your vehicle caused by installation of Kimax instruments or loss of time caused by
recalibration or repairs of Kimax instruments are not covered by Sense-tech Weighing Systems
ApS in any case.
Basic safety rules:
Before you start the installation procedure, make sure that the instrument has not suffered
any damage during transport.
Note that the Kimax 1 instruments must be installed and connected in accordance
with the regulations valid for the vehicle and country in question.
The Kimax 1 instruments must be protected from gravel, water spray from wheels
and other factors that may damage the instruments.
We recommend mounting the instruments in a position where it is protected from
water jets and rinse water.
Once you have decided where the instrument is to be mounted in the cabin, you must consider
the cable routing.
Special attention should be given to potential damaging factors such as hinging points for
tilting the cab.
Once you have decided where the instrument is to be mounted on the chassis, you must
consider the cable routing. Special attention should be given to tensile forces, cuts and other
factors that may damage the cables and hoses.
To Next Page
Loading...