HD LED
LINKABLE STRIP
LIGHT - 600mm
CODE: SE9072HD
Components
Important safety information
Tools required
INSTALLATION
INSTRUCTIONS
IMPORTANT: please read these instructions before commencing installation and retain for future reference.
1 x SE9072
HD LED
Linkable Strip Light
2 x Fixing Brackets
1 x Connector Cable
1 x Fitting Instructions
Please read these instructions carefully before attempting to install
this product. It is advisable to keep these instructions in a safe place
for further reference.
We recommend that you consult a qualified electrician.
All electrical installations must be carried out in accordance
with current IEE wiring regulations (BS7671).
These products must not be modified, if any modifications are
made, it may invalidate the warranty and may render the product
unsafe. These LED lights operate low voltage (24V).
Do not wire the individual LED light fittings directly to the mains.
This product is for indoor use only. Keep out of moisture and use
only in dry rooms.
• If in doubt installation must be carried out by a qualified
electrician.
• Install on smooth flat surface(s) only.
•
The Wattage of this product is 7.1W. Make sure that
the LED driver used with these fittings has an adequate
max wattage.
• We recommend using the SE40555 15W 24V LED Driver with this
fitting. You will be able to run a maximum of 2 fitting
s per driver.
Alternatively, use the SE40556 30W 24V LED Driver. A maximum
of 4 fittings can be run from this driver.
Safety instructions
1. Before commencing installation or maintenance, isolate the main
electrical supply for the appropriate circuit at the fuse board.
2. This product requires a 24V LED driver which is only
suitable for connecting to a 240V 50Hz supply.
3. The light should be mounted onto a secure surface.
4. Position lights where they will not be exposed to steam
or splashes etc.
5. Suitable for furniture lighting.
6. When the lamp expires the fitting must be replaced.
7. Class III safety extra low voltage (SELV).
Waste Electrical & Electronic Equipment (WEEE)
The Symbol on the product, or on the document accompanying the product, the crossed out
wheelie bin symbol, indicated that this product may not be treated as household waste.
Instead it shall be handed over to the applicable collection point for the recycling of electrical and
electronic waste.
Power DrillPZ1 Screw Bit10mm
Drill Bit
Pencil
To Next Page
Need help?
General
