Sentec SDM - Sensor Removal; Procedure for Sensor Removal and Docking

7
C) Sensor removal
1
When monitoring is completed, take off Ear Clip or
gently peel off Multi-Site Attachment Ring, then
remove sensor from retainer ring
i
s
o
p
r
o
p
a
n
o
l
7
0
%
2
Clean sensor and cable with Isopropanol 70% soaked
wipe.
3
39.4
50
30
PCO2
mmHg
84
140
50
PR
bpm
96
100
85
%SpO2
2.0 PI
14-04-28 15:28:31
Open Docking Station, put sensor into cradle inside
the door with the red light visible, close Docking
Station.
Note: Do not turn off the device.
I
s
o
p
r
o
p
a
n
o
l
7
0
%
4
Clean measurement site with Isopropanol 70%
soaked wipe. Note: Your home care provider will
ensure professional and hygenic maintenance of the
system once returned.
Important
Do not turn off the device at the end of the measurement.
The evaluation and analysis of the measurements is carried out by the home care provider. Analysis
of data is done by the supervising medical doctor.