SentexSystems ClikCard - Default Chapter; Table of Contents

To Next Page

To Previous Page

Rev. B Doc. 6001368

TABLE OF CONTENTS

PART 1 INTRODUCTION AND BASICS............................................................................................1

A. MOUNTING THE RECEIVER TO THE OPERATOR................................................................................ 1

B. MOUNTING THE RECEIVER REMOTELY ..............................................................................................1

PART 2 NARROW BAND GARAGE DOOR RECEIVER PROGRAMMING AND USE GUIDE........3

A. PROGRAMMING A TRANSMITTER INTO THE NARROW BAND GARAGE DOOR RECEIVER............ 3

B. ERASING TRANSMITTERS FROM THE NARROW BAND GARAGE DOOR RECEIVER....................... 3

PART 3 DATA VALIDATION AND NOISE DETECTION....................................................................4

A. DATA VALIDATION AND NOISE DETECTION........................................................................................4

PART 4 FCC REQUIREMENTS.........................................................................................................5

A. RADIO FREQUENCY............................................................................................................................... 5

This document is protected by copyright and may not be copied or adapted without the prior written consent of

Sentex. This document contains information proprietary to Sentex and such information may not be distributed

without the prior written consent of Sentex. The software and firmware included in the ClikCard Narrow Band

Residential Garage Door Receiver as they relate to this documentation are also protected by copyright and

contain information proprietary to Sentex.

Sentex Systems

Chatsworth, CA

Visit us at www.sentexsystems.com