Page 16 of 20 Doc. 6001036 Rev B
7 - VERIFYING ENTRIES
AREA 13 - VERIFYING ENTRIES
PURPOSE: Allows you to verify information that you have entered into the system's memory as well as
verifying the system capabilities and the status of available options.
SYSTEM PROMPT
EXAMPLE OF
TYPICAL ENTRY
IMPORTANT NOTES
ENTER AREA TO VERIFY (1-4):
1=TELEPHONE NUMBERS
2=ENTRY CODES
3=SYSTEM SET-UP
4=SYSTEM CAPACITIES/OPTIONS
1 + ENTER ENTERING A "1" OR A "2" WILL
ALLOW YOU TO CHECK INDIVIDUAL
ENTRIES THAT YOU HAVE MADE.
ENTERING A "3" WILL SHOW YOU
THE ENTRIES YOU HAVE MADE
REGARDING SYSTEM SETUP.
ENTERING A "4" WILL SHOW THE
CAPACITIES AND OPTIONS THAT
YOUR SYSTEM IS EQUIPPED WITH.
8 - DIRECTLY CONTROLLING SYSTEM RELAYS
In addition to the programming areas discussed on the previous pages, you may also directly control
the system's two relays once you have entered the programming mode. This control is accomplished by
entering a code when the menu prompt is given. These codes are not shown on the programming menu
because they are not part of a normal programming process and are not generally used on a regular basis.
They are not included in the "program mode" only to ensure that system relays are not activated or
deactivated except by authorized personnel.
REMOTE RELAY ACTIVATION
In order to remotely activate the system's two relays, you first need to enter the programming mode.
To enter the programming mode, call the telephone number designated for the system from a touch tone
telephone. The Horizon will answer the telephone line and will put out a modem carrier signal over the
telephone line. Next, enter a single asterisk ("
✱
") and the six-digit programming access code. Once you have
entered the asterisk, the modem signal will cease and after you have entered the programming mode, the
system will respond with two short beeps. Once you are in the programming mode, the code for controlling
the system's relays are as follows:
TIMED RELAY ACTIVATION
RELAY 1 = 99 + #
RELAY 2 = 95 + #
Once the relay has been activated, you will hear one long tone followed by two short tones.
SUSTAINED RELAY ACTIVATION (stays activated until released by operator)
RELAY 1 = 98 + #
RELAY 2 = 94 + #
Once the relay has been activated, you will hear one long tone followed by two short tones. This relay
will not deactivate until you "unlatch" it by initiating a timed activation of the same relay as described above.
To Next Page
Loading...