SENZ SDC320 - Maintenance and Cleaning; Water Container and Filter Base Cleaning; Lint Removal and Scrap Threads

20
MAINTENANCE
21
Empty the water container
Clean filter base
Filter door
Locking
lever
Maintenance cover
Filter
base
1. Hold and pull out the water container
with two hands.
2. Tilt the water container, pour out the
condensate water into the basin.
3. Install the water container.
Clean the scrap threads
Cleaning And Care
Empty the water container after each use, the
programme will be paused and the Full LED icon
wil illuminate if the water container is full during
the drying process. After the container is
emptied, the dryer can be restarted by pressing
【Start/Pause】button.
Do not drink the condensate water.
Do not use the dryer without the water container.
Warning!
！
1.
2.
3.
Open the door.
Take out the lint filter,pull
upward to take it out.
Clean the lint filter, clean the inner
ring and door gasket;wipe off the
scrap threads with your hand orrinse
with water and dry thoroughly.
4.Reinstall the filter door.
1.
2.
3.
Open the cover.
Unscrew both locking levers
towards each other.
Clean the filter base completely.
4.Re-insert the filter base!
5.Screw both locking levers.
6.Close the cover until it locks into
position.
Leave the dryer to cool down.
circulation, which will cause an extension of the
drying time and use more energy consumption.
Do disconnect the mains power cable before cleaning!
Do not operate the dryer without the filter!
Clean the filter after each use to prevent lint
accumulation inside the dryer.
The fluff accumulated on the filter will block the air
Note!