Trouble Shooting
Only authorised technicans can carry out repairs.
Before you call service, please check if you have
dealt with the fault yourself or if you have
followed the user instructions.
A technician will charge you for advice, even
during the warranty period.
Warning!
！
As necessary, approx. once every 2 months,
remove the fluff from the heat exchanger
using a sponge or soft brush.
When doing this, use gloves.
Clean heat exchanger
dampened.
The fluff can be removed more easily if it is first
Note!
22 23
Wash air condenser
Leave the dryer to cool down.
Residual water may leak, place an absorbent
cloth under the maintenance cover.
1.Unlock the maintenance cover.
2.Completely open maintenance cover.
3.Screw both locking levers towards each other.
4.Pool out the air condenser.
5.Clean the air condenser completely,drain
thoroughly.
6.Clean the seals.
7.Re-insert the air condenser, handle at the button!
8.Unscrew both lockinglevers.
9.Cloth the maintenance cover until it locks into
position.Plaese clean the air condenser approx,
once every 3 months if frequently used.
Do not damage the air condenser!
Clean with water only; do not use hard/sharp-
edged objects! Do not operate the dryer without
the air condenser!
Warning!
！
During drying,water may collect between the
window and the seal, but this does not affect
the function of your dryer!
Empty container
Dispiay
Reason
Solutions
Container is full
Water pump failure or water
level sensor failure
P lease contact your
local service center
if the problem
persists
Humidity sensor error
“Full” LED on
permanently
Child Lock + 9h
Child Lock + 6h
Temperature sensor error
Child Lock + 3h
Heating problem
To Next Page
Loading...