Additional Equipment Required
• GSM/GPRS cellular modem micro SIM Card with data
service
• WiFi capable tablet, PC or smartphone
Getting Started
• Insert 2 fully-charged batteries
into the Altus NR3. The positive
ends of the batteries should
point towards the front panel.
• Press rmly at the position
indicated by the grey arrow to
lock the chamber
ALTUS NR3 QUICK START GUIDE
System components
The following items are shipped as standard:
1. Altus NR3
2. USB data cable
3. 4 x Lithium Ion batteries (Standard 18650 Li-ion)
4. Altus NR3 Battery Charger (4-battery capacity)
5. Battery charger cables for mains and cigarette lighter
6. USB stick containing Altus NR3 manuals
This Quick Start Guide contains information on how to set
up and begin using your Altus NR3
2. Powering up the Altus NR3
• Power on by pressing the power button once. The unit
takes about 30 seconds to fully boot up.
*To switch o the Altus NR3, press the power button for 2 seconds
3. Turning on WiFi
• WiFi is turned on by default and will be available about
30 seconds after powering on
• If the WiFi LED is o, you can toggle WiFi on/o by
quickly pressing twice on the power
button
PRESS TWICE TO
TURN WIFI ON/OFF
PRESS ONCE
TO TURN ON*
4. Connecting to the Web Interface
• On your PC or mobile device, nd the WiFi network
beginning with Altus_NR3 then click Connect
• Open a browser and type 192.168.20.1 in the address bar
1. Installing the SIM card and batteries
• Charge the batteries for the
Altus NR3 in the 4-bay
charger provided.
• Install an activated SIM in the
left-hand battery slot
To Next Page
Need help?
General
