SereneLife SLPUMP50 - Deflation Operation; Deflation Process Steps; Precautions; Usage Precautions and Warnings

Figure 6Figure 5
www.SereneLifeHome.com
8
• Press the pressure unit switching button to switch
between the units, and press the power on/o button
to stop.
• When the pressure reaches the set value, the air pump will stop
working automatically.
• Upon the completion of ination, it will turn o automatically
without other operations within 2 minutes.
• After pulling out the DC plug, please take down the hose from
the air pump and air bag and store it.
• Notice: The factory set pressure value of the air pump is 10PSI
(10PSI=0.689BAR), and at the time of the secondary use, the set
pressure value for the last time use will be displayed by default.
• Notice: After powered on, if there is no operation within 2
minutes, the air pump will enter standby mode, and the
machine can be initiated by pressing the power switch button.
VIII. DEFLATION OPERATION
• Remove the hose from the ination inlet. Connect the end with
exible conduit adaptor (6)of the hose with the air pump
deation outlet (7), and twist clockwise to tighten it, as Figure
3, and the other end shall still be to the airbag.
• Press the button of the power switch of air pump, and start the
deation until all the gas is discharged, then the power can be
turned o to stop the deation.
www.SereneLifeHome.com
9
IX. PRECAUTIONS
• As this product has a lithium battery, it can work using the
battery, or the plug of the product can be inserted into the
cigarette lighter socket on the car for use.
• The applied power source must be the 12V DC power source (as
Figure 8).
• Do not block the ination inlet (1) and Deation outlet (2), and
ensure that the ination inlet (1) and Deation outlet (2) shall
remain smooth at all times.
• Observe the local waste treatment provisions, and it is not
allowed to throw the air pump away randomly.
• Don't use this product when the hose is damaged, and please
change the hose immediately.
• Don't pull out the hose when inating, because that the high
pressure may hurt the physical body.
• Don't make the air pump work for more than 30 minutes,
because that motor overheating may cause internal damage;
and the air pump shall be fully cooled for 30 minutes after
continuously working up to 30 minutes.
• Please don't use this air pump if any part is damaged, and contact
with the professional personnel to repair it.
• This product shall not be exposed to
the rain or immersed in water.
• In order to prevent risk, the ination
inlet shall not be forward to face or
body.
• Please don't not leave while inating.
Figure 7
Figure 8