Sertain S4540 - CPR Warning and Procedure; 3.15 Headrest Cushion Adjustment; 3.16 Fitting Sliding Activity Tray

To Next Page

To Previous Page

DO NOT USE CHAIR UNTIL YOU HAVE FULLY READ THE INSTRUCTIONS

CPR WARNING:

If you or your facility decides to use this chair for CPR purposes, it is only to be performed if the chair has a

LAY FLAT SUPPORT BAR (see Section 3.14) tted to manufacturers’ specications and the bar is at 90 o (degrees) to

the BACKREST and the FLOOR – see following conditions.

In the event you need to perform CPR on a client in this chair you must have fully read and understood everything on

this document and the following must be strictly adhered to;

1. If you have a LAY FLAT SUPPORT BAR – SWINGDOWN STYLE it must be fully engaged FIRST (see Section 3.14 &

Figure 14a)

2. Then fully activate AUTO FLAT SYSTEM (see Section 3.13 & Figure 13).

3. You have assessed the need for a CPR assistance device such as a CPR board which may be required for eective

CPR due to the Pressure Care Seating system in use on this chair. Your clinical team needs to assess this as

the manufacturer provides the chair with multi-positioning outcomes but cannot guarantee or advise on the

eectiveness of the patient outcomes from a CPR event due to a multitude of external factors.

3.15 Headrest Cushion Adjustment - (Models with

this feature)

Raise or lower headrest cushion to desired position by adjusting the

headrest ap via the fastening system (see gure 15).

3.16 Fitting Sliding Activity Tray (Models with this feature)

Apply brakes before tting tray.

Tray locating lugs are situated on front of the chair arm underneath

the tray retaining tube.

Disengage locating pins (pull pin down and ¼ turn), slide the table

arms into desired position, engage locking pins (¼ turn in reverse).

NOTE: If tray is to be locked make sure pins are located and locked

securely for client and carer’s safety and that you have any

relevant approvals for use of this type of device.

Operating Instructions

Figure 15