DO NOT USE CHAIR UNTIL YOU HAVE FULLY READ THE INSTRUCTIONS
Conrm (2 beeps):
Reset or Entering Manual Mode:
Hoot:
Over-heating:
Medium level battery (only CB20):
A CONSTANT BEEP when any button is pressed indicates power management error in the CB. Ensure the system is
connected to MAINS 240V and leave without operating for minimum 6 hours. If, after 6 hours the problem still exists,
replace the CB.
BATTERY LOW is indicated by a 1 second beep when a function is activated.
Charge or replace the battery.
(If the temperature exceeds a pre-dened level the driving stops followed by a 5s beep tone. If the next activation
is carried out before the temperature level is at an acceptable level, driving is not allowed and the 5s beep tone comes up).
OVERHEATING is indicated by a 5 second beep when a function is activated. Allow the system to cool down before
operating.
100 ms pause
100 ms beep
500 ms beep
50 ms pause
5s beep
1s beep
Technical Data
22 © 2019Careleda M-03 WI-204rev 6 Edited 29.10.2019
To Next Page
Loading...