DO NOT USE CHAIR UNTIL YOU HAVE FULLY READ THE INSTRUCTIONS
3. OPERATING INSTRUCTIONS
3.1 Power Cord Use and Storage - See diagram
When not in use, the power cord is stored, as shown in Figure 1. To charge
the chair batteries, park chair near to a power source, un-wrap the power
cord, plug it into power source and switch on power. Ensure that the
chair and cord are not left in an unsafe/hazardous position. Follow your
organizations policy on the use of power cords. Always STOW cord before
moving chair.
3.2 Seat Tilt Adjustment
Before tilting seat make sure it is safe to do so, make sure the client/
patient and the carer are safe and the client is positioned correctly. Also
make sure that no items, (equipment etc.), are placed over or under any
part of the chair before operating this feature.
Tilt chair to desired position by depressing the left or right hand buttons
on the handset either side of the SEAT icon as shown in Figure 2.
3.3 Seat Height Adjustment (for models with this feature)
Before adjusting seat height make sure it is safe to do so, make sure
the client/patient and the carer are safe and the client is positioned
correctly.
Note: It is best to maintain this function, chair power cord should be
connected to power supply. Power cord must be unplugged from power
supply and stowed carefully on chair before transporting client or
moving chair.
To Raise Chair
Make sure that no items, (equipment etc.), are placed over the chair.
Raise the chair to the desired height by depressing the correct buttons on
the handset either side of the HILO icon. HILO icon as shown in Figure 3.
To Lower Chair
Make sure that no items, (equipment etc.), are placed under the chair.
Lower the chair to the desired height by depressing the correct buttons
on the handset either side of the HILO icon as shown in Figure 3.
CLIENT/PATIENT must not be left unattended when seat is RAISED.
3.4
Before adjusting backrest, make sure it is safe to do so, make sure the
client/patient and the carer are safe and the client is positioned correctly
including limbs, clothing, etc. Make sure no item (equipment, persons,
etc.) obstruct the path of the backrest, to prevent injury to client or carer,
and also prevent damage to your chair.
Back Rest Adjustment – Electric (for models with this feature)
Adjust backrest to desired position by depressing the left or right hand
buttons on the handset either side of the Back Rest icon as shown in
Figure 4.1.
Back Rest Adjustment – Manual (for models with this feature)
Adjust backrest to desired position by supporting the backrest and
operating the hand lever located on the push handle – refer to Figure 4.2
CLIENT/PATIENT/ANY PERSONS must not sit on backrest or at any
time egress over the backrest when it is reclined.
Figure 1
Figure 2
Figure 3
Figure 4.1
Figure 4.2
4 © 2019Careleda M-03 WI-204rev 6 Edited 29.10.2019
To Next Page
Loading...