INSTALLATION/OPERATION
IMPORTANT!!! PLEASE READ BEFORE INSTALLATION
■ If the unit has recently been transported, please let unit stand still for
a minimum of 24 hours before plugging it in.
■ Make sure that the unit drops down to desired temperature before loading
the unit with product.
■ Maker sure that there is proper ventilation around the unit in the area where
it will operate.
■ Make sure all accessories are installed (i.e. poly pans, drawers, casters)
before plugging the unit in.
■ Please read through the Operation / Owners Manual in its entirety.
UNCRATING
TOOLS REQUIRED
• Adjustable Wrench
• Phillips Screwdriver
• Level
The following procedure is recommended for uncrating the unit:
A. Remove the outer packaging, (cardboard and bubbles or Styrofoam corners
and clear plastic). Inspect for concealed damage. Again, immediately file a
claim with the freight carrier if there is damage.
B. Move your unit as close to the final location as possible before removing the
wooden skid.
CABINET LOCATION GUIDELINES
■ Install the unit on strong and leveled surfaces
－unit may make unpleasant noises if surface is uneven
－unit may malfunction if surface is uneven
■ Install the unit in an indoor, well-ventilated area
－unit performs more efficiently in a well-ventilated area
－for best performance, please maintain clearance of 3” on the back of the
unit
－outdoor use may cause decreased efficiency and damage to the unit
■ Avoid installation in a high humidity and/or dusty area
－humidity could cause unit to rust and decrease efficiency of the unit
－dust collected on condenser coil will cause unit to malfunction. Clean the
condenser at least once a month with a brush or clean cloth
－malfunction due to dirty condenser will void warranty
To Next Page
Loading...
