SERV-WARE ER5-HC - Table of Contents; Receiving & Inspecting Equipment

www.servware.com
800•768•5953
Service, Installation & Care Manual
3
CONTENTS
SERIAL NUMBER INFORMATION
RECEIVING AND INSPECTING THE EQUIPMENT
RECEIVING & INSPECTING EQUIPMENT............................................................3
SPECIFICATIONS.......................................................................................................4
INSTALLATION...........................................................................................................5
OPERATION.................................................................................................................6
MAINTENANCE..........................................................................................................8
WIRING DIAGRAM....................................................................................................11
© Copyright 2019 Ser-Ware Products Incorporated. All rights reserved.
Reproduction without written permission is prohibited.
The serial number of all self-contained refrigerators and freezers is located inside the unit on the
left hand side near the top on the wall.
Always have the serial number of your unit available when calling for parts or service.
This manual covers standard units only. If you have a custom unit, consult the customer service
department at the number listed on the last page.
Even though most equipment is shipped crated, care should be taken during unloading so the
equipment is not damaged while being moved into the building.
1. Visually inspect the exterior of the package and skid or container. Any damage should be noted
and reported to the delivering carrier immediately.
2. If damaged, open and inspect the contents with the carrier.
3. In the event that the exterior is not damaged, yet upon opening, there is concealed damage to
the equipment, notify the carrier. Notication should be made verbally as well as in written form.
4. Request an inspection by the shipping company of the damaged equipment. This should be
done within 10 days from receipt of the equipment.
5. Be certain to check the compressor compartment housing and visually inspect the refrigeration
package. Be sure lines are secure and base is still intact.
6. Freight carriers can supply the necessary damage forms upon request.
7. Retain all crating material until an inspection has been made or waived.