What to do if my SERVIS W61244F2W is not draining water?
If your SERVIS Washing Machine isn't draining water, it could be due to a few reasons. First, inspect the drain hose for any bends, twists, or kinks and straighten them out. Second, make sure that your laundry is spread out, not too tightly packed in the drum. For the pump filter obstruction, see page 34 for detailed instructions.
Why is my SERVIS W61244F2W not receiving water?
If your SERVIS Washing Machine isn't receiving water, the cold water supply tap may be off; ensure it is fully turned on. Also, the water fill hose might be bent, twisted, kinked, or trapped; check for these issues and correct them.
Why doesn't the spin cycle take place in my SERVIS W61244F2W?
The spin cycle may not be happening because the in-built sensor has stopped your SERVIS Washing Machine from operating with an out-of-balance load. To prevent this, avoid small wash loads containing items that could become heavy through water absorption.
Why is my SERVIS W61244F2W not operating?
Your SERVIS Washing Machine might not be operating due to several reasons. First, ensure it is plugged in and switched on at the mains. Second, check that the program dial is not in the off position and select the desired program. Lastly, make sure the door is properly shut, listening for a ‘click’ sound.
Why is my SERVIS W61244F2W vibrating so much?
If your SERVIS Washing Machine is vibrating, it might be because the feet of your machine are not correctly adjusted. See page 11 for further information. Another reason could be that the transit bolts have not been removed. See page 9 for further information.
How to deal with excessive foam in the detergent drawer of my SERVIS Washing Machine?
Excessive foam in the detergent drawer of your SERVIS Washing Machine may be due to using too much or the wrong detergent. If you've used too much detergent, press the Start/Pause button, then dilute one tablespoon of softener into 1/2 litre of water and pour it into the detergent drawer. Press the Start/Pause button again after 5-10 minutes. Also, ensure you only use detergents specifically produced for automatic Washing Machines.
Why is the washing result from my SERVIS W61244F2W not as expected?
If the washing result from your SERVIS Washing Machine isn't as expected, it could be because your laundry is too dirty for the selected program, so use the information on pages 25 and 26 to select the most appropriate program. Also, you may not have used enough detergent, so use the amount of detergent as instructed on the packaging. Finally, there might be too much laundry in your Washing Machine, so check that the maximum capacity of your Washing Machine is not exceeded; see pages 25 and 26 for more information.
Why does water drain from my SERVIS W61244F2W as soon as it fills?
If the water from your SERVIS Washing Machine drains as soon as it fills, the end of the water drain hose may be too low. Check that the drain hose is at a suitable height; see page 14 for more information.
General| Brand | SERVIS |
|---|---|
| Model | W61244F2W |
| Category | Washing machine |
| Language | English |
To Next Page