When the position of one of the knobs or switches is changed,
the value is updated and now the knob marker or switch posi-
tion will correspond with the actual value.
NOTE: In some cases the switches has to be changed twice to
update the value. Example: We are on preset 1, on this pre-
set the boost section is active (boost led ON) but the boost
switch is in OFF position. If we want to deactivate the
boost, we first have to switch the boost ON, and again switch
it OFF. This operation will switch off the boost section (led
OFF).
RELAY TRUE BYPASS
The Glam uses a a Relay True Bypass system. This system
uses a clickless switch, a PIC microcontroller and a high
quality relay to do the bypass operation.
This system has a much higher durability than the 3PDT
switches usually used on True Bypass pedals.
COMPONENTS
-1% Metal film resistors
-WIMA capacitors made in Germany
-Alpha potentiometers
-Neutrik Jacks
CONTACT
If you have any questions, suggestions or critic don’t
hesitate to contact us on info@servuspedale.com
www.servuspedale.com
To Next Page
Loading...