ST – II Series POWER SUPPLIES USER INSTRUCTIONS
Battery Connection Procedures:
Battery should be connected as per the following steps.
Turn power supply off and all 12 volt equipment connected to power supply.
Connect positive battery terminal to “Batt +VE” power supply terminal.
Connect negative battery terminal to “Batt -VE” power supply terminal or negative chassis ground.
If battery is connected to chassis, ensure a connection exist from chassis to “Batt –VE”
terminal of power supply.
Battery Disconnection Procedures:
Battery should be disconnected as per the following steps.
Turn power supply off and all 12 volt equipment connected to power supply.
Disconnect negative battery terminal connection to “Batt –VE” power supply terminal or negative
chassis ground.
1. Disconnect positive battery terminal to “Batt +VE” power supply terminal.
Page 6 of 11 Issue F
To Next Page
Loading...