Need help?Do you have a question about the Setec ST-III Series and is the answer not in the manual?
General| Brand | Setec |
|---|---|
| Model | ST-III Series |
| Category | Power Supply |
| Language | English |
Essential safety guidelines for installing and operating the power supply to prevent injury.
Function to prevent deep battery discharge by automatically disconnecting at low voltage.
Maintains battery charge at a low rate to prolong life, especially for flat batteries.
Allows manual disconnection of the battery from loads and charger via a remote switch.
Explanation of the three LED indicators (Mains, Battery, Fault) on the front fascia.
Provides an alternative +12V DC input for powering loads and charging batteries when mains are absent.
Details automatic protection against overload, short circuit, over-voltage, and reverse connection.
Information on load and battery fuses for fault protection and discrimination.
Ensuring user access is restricted to the front panel of the unit for safety.
Specifies that installation must be performed by suitably qualified personnel only.
Minimum clearances and ventilation needed to prevent overheating and premature thermal shutdown.
Provides dimensions, mounting hole locations, and cut-out sizes for installation.
Correct positioning of the unit during installation to prevent thermal shutdown.
Guidance on selecting appropriate DC cable sizes based on current and voltage drop.
Step-by-step instructions for safely connecting batteries to the power supply.
Step-by-step instructions for safely disconnecting batteries from the power supply.
Information on suitable battery types and charging recommendations for optimal performance.
Emphasizes that only qualified personnel should service the unit due to hazardous voltages.
Instructions for replacing DC load and battery fuses, specifying types and ratings.
Instructions to consult your Setec dealer for any repair or after-sales service needs.
To Next Page
