Under the refrigerator is on standby, Press and hold the
" " and " " buttons ON THE RIGHT BIN at the
same time, into the settings menu, then short press the
" " button to enter the battery protection function, and
then press the " " or " " to switch between
HIGH/MID/LOW level. The right indicator shows the
battery protection settings. H is defaulted by factory.
+
-
+
-
This function is designed to prevent over-discharge and
battery depletion. When the measured DC voltage is
below the Cut-of f value, the compressor will shut of f to
prevent battery depletion. After the voltage is higher
than Start-up value, the compressor will go back to work
again. Improper protection setting or low-power battery
may cause E1 error, please lower the battery protection
or recharge the battery in time.
09
LOW
MID
HIGH
To Next Page
