EasyManua.ls Logo

SEVERIN KS 9804 User Manual

SEVERIN KS 9804
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Dear Customer,
Before using the appliance, the user should read the following instructions carefully.
Connection to the mains supply
The appliance should only be connected to an earthed socket installed in accordance with
the regulations. Make sure that the supply voltage corresponds with the voltage marked on
the rating label. This product complies with all binding CE labelling directives.
Do not operate this unit by means of a transformer or, together with other electrical
appliances, by means of an extension cable.
To prevent noise vibration, ensure that the power cord does not touch any part of the
rear of the unit (e.g. the heat-exchanger).
General information
This compressor-freezer unit is designed for deep-freezing and long-term storage of deep-
frozen food, as well as for making ice-cubes.
The unit is classed as Climate Class ‘N’ (Normal) and designed for domestic use. It complies
with all relevant norms for domestic freezer appliances.
Important safety instructions
To prevent the risk of personal injury or damage to the freezer, the unit must only be
transported while in its original packaging. For unpacking and installation, 2 persons are
needed.
The cooling circuit in this appliance contains the refrigerant isobutane
(R600a), a natural gas with a high level of environmental
compatibility, which is nevertheless flammable. Ensure, therefore,
that none of the components of the refrigerant circuit become
damaged during transportation and installation of the appliance. If
damage to the cooling circuit does occur, do not switch on or connect
the appliance to the mains power. In the case that there is an open fire or any other
sources of ignition in the vicinity of the refrigerant gas, make sure it is removed
immediately from this area and that the room is then thoroughly ventilated.
Warning: Do not damage the cooling circuit. Any escaping refrigerant causes damage to
the eyes; there is also a danger of the gas igniting.
Warning: Keep ventilation openings, in the appliance enclosure or in the built-in
structure, clear of obstruction. Sufficient ventilation must be ensured at all times.
Warning: Do not use any external device (e.g.; heaters or heating fans) to accelerate de-
frosting; follow only the methods recommended in this manual.
The ice removed from the unit during de-frosting is not suitable for human consumption.
Warning: Do not operate any electrical appliances (e.g. ice makers) inside the freezer’s
food storage compartment.
Before it is connected to the mains power, the unit must be thoroughly checked for
transport damage, including its power cord.
The power cord should be regularly examined for any signs of damage. In the event of
such damage being found, the appliance must no longer be used.
9
Freezer
Question and Answer IconNeed help?

Do you have a question about the SEVERIN KS 9804 and is the answer not in the manual?

SEVERIN KS 9804 Specifications

General IconGeneral
BrandSEVERIN
ModelKS 9804
CategoryFreezer
LanguageEnglish

Summary

Connection to the mains supply

Power connection guidelines

Connect appliance to an earthed socket, verify voltage. Do not use transformers/extension cords.

General information

Appliance description and classification

Compressor-freezer for deep-freezing, ice-cubes. Class N, domestic use. Complies with norms.

Important safety instructions

Transportation and handling safety

Transport in original packaging. Two persons needed for unpacking/installation.

Refrigerant handling and fire safety

Contains flammable R600a. Avoid circuit damage. Ventilate if gas escapes.

Ventilation requirements

Keep ventilation openings clear for sufficient air circulation.

Defrosting precautions

Do not use external heaters for defrosting. Ice from defrosting is not for consumption.

Internal usage warnings

Do not operate electrical appliances inside the freezer.

Electrical safety checks

Check for transport damage before connecting. Inspect power cord regularly for damage.

General fire prevention

Do not place heat-generating appliances on top. Avoid liquids near electrical insulation.

Food storage guidelines

Store only common household food. Store alcoholic drinks upright. Do not consume expired or refrozen food.

Structural integrity

Do not lean or put undue weight on shelves or door.

Ignition source protection

Protect interior from open flames and ignition sources.

Glass bottle warning

Do not store carbonated/freezable liquids in glass bottles; they may burst.

Disconnecting power

Remove plug for malfunctions, before defrosting, and during cleaning.

Child safety

Ensure adult supervision; children must not play with the appliance.

Service and modifications

Repairs/modifications must be done by authorized personnel.

Extended non-use

Keep door open if unit is not used for an extended period.

Disposal information

Note insulation agent (cyclopenthane) and refrigerant (R600a) for disposal.

Familiarisation

Component identification

Lists key parts: temperature control, shelf, feet, door, vaporiser.

Initial setup steps

Remove packaging. Check for transport damage. Clean before connecting.

Installation

Location and environment

Install in well-ventilated, dry room. Ambient temp 16-32°C, humidity max 70%.

Clearance requirements

Minimum clearances: 100mm rear, 200mm sides, 300mm top. 160° door swing. 2cm lateral for adjacent units.

Stability and leveling

Use adjustable feet for stability. Install at a slight rearward angle for auto-closing.

Ventilation design

Ensure heated air around the rear can circulate freely and is not obstructed.

Reversible door instructions

Step-by-step guide to reverse door hinges for left or right opening.

Temperature control

Setting the temperature

Set to 5 for freezing, then 3 for home use. Position 0 switches off cooling.

Operating temperature factors

Affected by ambient temp, food, door opening frequency/duration. Adjust as needed.

Freezing and storing food

Food types and preparation

Store frozen/pre-frozen food. Do not mix fresh/warm food with frozen. Portion food before freezing.

Storing pre-frozen food

Follow packaging info. Do not exceed 3 months if no info is present.

Buying frozen food

Verify food is frozen and packaging is undamaged. Transport in suitable containers.

Packaging and labeling

Use transparent plastic, bags, or foil. Label items with food type, date, and use-by date.

Making ice cubes

Fill ice-cube tray 3/4 full. Remove cubes easily after 5 mins at room temp.

De-frosting and cleaning

Cleaning preparation

Always unplug before cleaning. Do not pour water over unit. Avoid abrasives/harsh solutions.

Defrosting procedure

Defrost when ice layer reaches 3-5mm. Remove food, unplug, leave door open.

Post-defrosting cleaning

Clean with warm water/mild detergent. Wipe dry and air out. Do not damage rating plate.

Exterior dust removal

Regularly clean ventilation slots with brush/vacuum to prevent energy increase.

Trouble-shooting

Typical operating sounds

Sounds from compressor motor and cooling agent flow are normal.

Malfunction diagnosis

Table lists common problems, causes, and solutions. Consult if issues persist.

Transporting the appliance

Transport guidelines

Transport only in vertical position, max 30° tilt. Secure against shock and vibration.

Disposal

Disposal procedure

Render unusable, cut cord. Dispose via special waste points. Handle refrigerant/foam agent responsibly.

Guarantee

Warranty terms

Two-year warranty against defects. Excludes wear, tear, misuse, unauthorized repairs.

Information needed by the Customer Service

Contacting customer service

Provide detailed fault description and article number (KS XXXX) for efficient service.

Technical specifications

Appliance details

Lists model, energy class, capacity, climate class, dimensions, weight, and electrical data.

Related product manuals