Seville Classics UltraShield WEB657 - Parts List; Assembly Instructions; Step 1: Align Feet and Attach Clamps; Step 2: Fit Gaskets and Attach Small Screws

Parts List
Please make sure you have all the parts on this list.
If you’re missing parts, contact us for replacements at
(800) 323-5565 or send an email to Support@SevilleClassics.com
1
A. Panels (1)
D. Gaskets (4)
B. Clamps (2)
E. Long screws (2)
C. Feet (2)
F. Small screws (4)
Step 1.
Align FEET (C) side-by-side by aligning
the screw holes.
Pull apart CLAMPS (B).
Fit boom CLAMPS (B) over holes with
front side (no hole) towards logo.
Step 2.
Fit GASKETS (D) into CLAMPS (B).
Aach with SMALL SCREWS (F).
Assembly Instrucons
Required tools (not included): Phillips screwdriver
2
Step 3.
Lay ACRYLIC PANEL (A) at on table.
TIP: Do not remove panels from bags.
Open one side of bags to install feet.
Fit boom of panel into
metal lip of the CLAMP (B).
Step 4.
Slide upper CLAMP (B) onto lower
clamp. Make sure panel sits above
the metal lip.
Press together unl snug.
Step 5.
Aach CLAMPS (B) with LONG
SCREWS (E). Repeat for other side.