Need help?Do you have a question about the SEW-Eurodrive S Series and is the answer not in the manual?
General| Gear unit sizes | S37, S47, S57, S67, S77, S87, S97 |
|---|---|
| Power Range | 0.12 kW |
| Voltage Range | According to motor |
| Frequency Range | According to motor |
| Cooling Method | According to motor |
| Efficiency Class | According to motor |
| Mounting Type | Foot-mounted or flange-mounted |
Defines user responsibilities for safety compliance and qualified personnel for tasks.
Specifies the intended industrial applications and compliance with relevant directives.
Covers ensuring correct installation, protecting against mechanical strain, and prohibited applications.
Details pre-startup checks for rotation, noise, and handling operational changes.
Illustrates the basic components of R..07 to R..167 helical gear units.
Shows the basic components of F..27 to F..157 parallel-shaft helical gear units.
Depicts the fundamental structure of K..19/K..29 helical-bevel gear units.
Illustrates the fundamental structure of K..39/K..49 helical-bevel gear units.
Shows the basic structure of K..37 to K..187 helical-bevel gear units.
Depicts the fundamental structure of S..37 to S..97 helical-worm gear units.
Illustrates the basic structure of W..10 to W..30 SPIROPLAN® gear units.
Shows the fundamental structure of W..29/W..39 SPIROPLAN® gear units.
Depicts the basic structure of W..37/W..47 SPIROPLAN® gear units.
Explains the nameplate and type designation of explosion-protected gear units.
Details the type designation system for various gear unit series like R, F, S, K, and W.
Covers designs II2GD/II3GD, ambient temp., temp. class, protection degree, and conditions.
Provides detailed instructions and critical safety warnings for installing the gear unit.
Details installation, fitting motors, and permitted loads for AMS.. adapters.
Covers installation, motor mounting, and permitted loads for AQS.. adapters.
Explains installation, WEX speed monitor setup, and connecting monitoring devices.
Provides instructions for directly mounting a motor on a gear unit, including sealant selection and tightening torques.
Lists essential activities before and during startup, especially for explosive atmospheres.
Provides instructions for installing and adjusting the WEX speed monitor and its components.
Lists obligatory intervals and corresponding measures for regular inspection and maintenance.
Explains how to check oil levels and change oil based on gear unit type, size, and mounting position.
Lists recommended bearing greases and their properties.
Presents a table of recommended lubricants based on gear unit type, temperature, and manufacturer.
Provides a table of common gear unit faults, their possible causes, and recommended measures.
To Next Page