Need help?Do you have a question about the Sewhacnm SI 400 and is the answer not in the manual?
Details the comprehensive technical specifications of the SI 400.
Details the function of each key on the SI 400's keypad.
Guides on connecting and installing load cells to the indicator.
Details the procedure for calibrating the indicator using test weights.
Explains how to set the maximum weighing capacity for the scale.
Guides on configuring decimal points and division values.
Explains how to calculate the span value during calibration.
Outlines the process for calibration without using test weights.
Explains how to input the maximum capacity of the load cell.
Describes measuring dead weight in simulation calibration mode.
Explains how to access and configure F-FUNCTION parameters.
Describes the process of measuring the scale's dead weight.
Details how to initiate and perform simulation calibration.
Guides on setting digit and division for simulation calibration.
Details how to enter the load cell's rated output voltage (mV).
Guides on entering the F-FUNCTION setting mode.
General| Brand | Sewhacnm |
|---|---|
| Model | SI 400 |
| Category | Touch Panel |
| Language | English |
To Next Page